-
The HYDROS WiFi Smart Plug is an outlet designed to work in tandem with any HYDROS controller (not included). Create rules and schedules to turn on and off different equipment such as a pump, light, heater, UV sterilizer, and whatever else you may want to control on-demand or put on a schedule. Program up to 8 WiFi plugs/power strips per Hydros controller. The Smart Plugs can monitor real-time electrical consumption and send alerts if a device draws power above or below a certain threshold.
-
The HYDROS Power 4 WiFi Power Strip is a power bar designed to work with the CoralVue HYDROS controller and app via WiFi. Program up to 8 WiFi plugs/power strips per Hydros controller. Requires HYDROS app and HYDROS Control unit- NOT included.
-
The HYDROS Temperature Sensor has a long 79” cord that plugs into any Sense Port on the Control 2, Control 4, X3, and future HYDROS devices. This sensor must be plugged into a HYDROS Controller for this sort of automation to occur. HYDROS Controller NOT included.
-
The HYDROS Pinpoint pH Probe is a Probe port accessory. Set target pH ranges for your system on the app and receive immediate mobile alerts when the pH rises or falls out of the safe range. The HYDROS Pinpoint pH Probe requires the HYDROS app and HYDROS Control unit-NOT included.
-
Measure & monitor your system's Oxidation Reduction Potential value. The 10ft cable allows for long range placement in your system. Requires HYDROS app and HYDROS Control unit- NOT included.
-
Detect two points of reference for accurate pH monitoring. Use calibration solutions that are on either spectrum of the pH you intend to monitor. For aquaponic tanks where the pH is normally 7.8-8.5, use calibration solutions 7.0 and 10.01. For aquaponic systems where the pH is normally below 7.0, use 4.01 and 7.01 calibration solutions. 4.01 pH - The lower threshold reading your pH monitor or controller will require for use with calcium reactors for saltwater aquariums, solutions below 7.00 pH, and also most aquaponic systems. 7.01 pH - Neutral pH calibration packet. This is used by almost all pH monitors and controllers for calibration. 10.01 pH - The higher threshold reading your pH monitor or controller will require for use with saltwater aquariums or solutions above 7.00 pH Calibration packets can be stored in a cool dry area for up to 1 year.
-
The HYDROS Water Level Sensor senses when your tank or sump needs to be topped off. The sensor plugs into any Sense Port on a HYDROS device (NOT included) and does not require any additional power source.
-
The valve provides easy on/off water flow. The HYDROS DC Solenoid Valve is a Drive Port accessory for HYDROS Control 2 and Control 4.
-
This 9ft long extension cable is a HYDROS Sense Accessory for the HYDROS Control monitors.
-
The Terminator must be installed as part of a collective on any open Command Bus ports. A terminator is needed to connect the units regardless of the command bus cable.
-
This 6ft HYDROS System Command Bus Cable allows HYDROS devices to power and communicate with other HYDROS devices. This is a DATA & POWER cable that CAN supply power from unit to unit.
