Your Cart  |  Items: 0  |  Total: 0 View Cart

AquaParts 12″Bell Siphon with Media Guard

AquaParts 12″Bell Siphon with Media Guard

An Aquaponics Bell Siphon is an elegant way to drain your grow bed in a flood and drain aquaponics system without using a timer to turn your pump on and off.

(Note: The design of this siphon assumes 12″ of media depth. It will not work properly with more than 13″, and can be modified by shortening the stand pipe for beds with less than 11″ of media.)


SKU: CMFAS108 Category:


Why use a siphon?

  •  No more timer – You will no longer need nor want a timer to control your pump. This eliminates:
    • The cost of the timer
    • The risk of timer failure
  • Pump runs continuously – Pumps that run continuously suffer less wear and tear. This may result in a longer pump life.
  • More aeration -If you are diverting part of your water stream back into your fish tank for aeration, using a siphon to drain your beds will increase the aeration you deliver to your fish tank (since aeration based on diverting a portion of the water stream only works while your pump is running).
  • Educational opportunity – A bell siphon is loaded with basic physics. This creates a great opportunity to teach students about partial vacuums, low pressure, pressure equalization, the impact of flow rates on siphon performance, and the force behind it all – gravity.

How does it work?

Starting from the point of a drained grow bed, the grow bed will fill with water. When the water level reaches the top of the stand pipe inside the Bell, water will start running through the siphon and out through the Drain Pipes and into your tank. Soon, the siphon will “fire”. At this point, the water in your grow bed will be rapidly drawn through the siphon and the water level in your grow bed will rapidly drop all the way to the base of your grow bed. When this happens, air will enter the Bell through the slits at the bottom of theBell, and the siphon will begin to “break”. When the siphon breaks, water will stop flowing through the Drain Pipes. Since the pump is running continuously, water will immediately begin to fill the grow bed and the cycle will repeat – indefinitely.

Siphon is 2″ x 12″ and accompanying media guard is 4″ x 12″.

Illustrated instructions are included.

Wholesale Minimum Quantity: 4

Additional information

Weight 5 lbs
Dimensions 13 x 8 x 8 in


There are no reviews yet.

Be the first to review “AquaParts 12″Bell Siphon with Media Guard”

Your email address will not be published.

You may also like…